Hi there,
I was wondering if you could explain the Dyn ICA output for spatial and temporal properties. I assume the spatial properties are a representation of spatially connected regions throughout the scan? But is each dynamic factor (circuit/state?) a representation of several pairs of regions connected through time? I am running an analysis where I am correlating a behavioral variable (answers on a questionnaire) with these temporal factors, but I am unsure of how to interpret the results. For example, the attached spatial component is positively correlated with my behavioral measurement. Does it mean that this entire "state" should be considered as correlated, or just the pairs of regions? Any help would be appreciated, thank you!
I was wondering if you could explain the Dyn ICA output for spatial and temporal properties. I assume the spatial properties are a representation of spatially connected regions throughout the scan? But is each dynamic factor (circuit/state?) a representation of several pairs of regions connected through time? I am running an analysis where I am correlating a behavioral variable (answers on a questionnaire) with these temporal factors, but I am unsure of how to interpret the results. For example, the attached spatial component is positively correlated with my behavioral measurement. Does it mean that this entire "state" should be considered as correlated, or just the pairs of regions? Any help would be appreciated, thank you!