Hi,
I am new to CONN and I'm trying to run task-based FC analyses. I have read elsewhere that a high pass band filter around [0.008 Inf] would be appropriate for this kind of analysis (https://www.nitrc.org/forum/message.php?msg_id=11196). This is what I wrote in the ''Conditions'' part of the Setup section.
However when it comes to Denoising, I also have to choose a high pass band filter that is set to [0.008 < f < 0.009] by default. Should I put [0.008 Inf] once again? What is the difference between the high pass band filter in these two steps?
I am new to CONN and I'm trying to run task-based FC analyses. I have read elsewhere that a high pass band filter around [0.008 Inf] would be appropriate for this kind of analysis (https://www.nitrc.org/forum/message.php?msg_id=11196). This is what I wrote in the ''Conditions'' part of the Setup section.
However when it comes to Denoising, I also have to choose a high pass band filter that is set to [0.008 < f < 0.009] by default. Should I put [0.008 Inf] once again? What is the difference between the high pass band filter in these two steps?